Posiflex JIVA KS-7215 - Manual (Page 12)

Part 12
SIDE MOUNT UPGRADE KIT
Remove the 2 circled screws in last picture above to remove the cover for side
mount upgrade kit. Take out the cable inside this cover as
circled in right picture and connect it to connector inside
the side mount upgrade kit as arrowed in same picture.
Gently arrange the excessive length of this cable back in
the hole and screw-fit it back to the position originally
occupied by the cover. Please reserve the cover if there is
chance to have the side mount kit removed in the future.
BASE MOUNT UPGRADE KIT
Please follow the instructions on the manual that comes along with the
customer display PD- 306 / 309 / 2602 / 2605 / 76X2 / 76X4 /LM-8015/LM-
8025/LM/TM-8045/LM-8055 if installed.
REAR TOP MOUNT UPGRADE KIT
1. For Customer Pole Display:
Please apply carefully the 2 small fixation shoulder
screws that come along with PD-310 or PD-2604 to
the back of KS-6915/6917/7215/7217 at the screw
hole triangle marked in the 2 upper right pictures.
However please do not screw them to the bottom but
at a position that is about 1 turn loose from the
bottom. Similarly please loosen the screws by 1 turn for some KS models with
these 2 screws preinstalled. Hook the rear bracket of the upgrade kit onto the
shoulder screws with the large circular holes. Slide to the right of the upgrade
kit and gently tighten the shoulder screws. Do not overdo the tightening or
unrecoverable thread damage will occur. Arrange the interface cable to
enter the base stand at a notch on the edge near the lock/release button as
indicated by white arrow in above picture. Remember to enable the +5 V DC
supply in the COM port of the main unit for the upgrade kit if the serial
interface model is used. The power supply in the I/O port must be disabled if it
is no longer to support these intended devices otherwise any damage or loss
caused consequently shall be out of product warranty!
2. For Second LCD Display
There are two parts of LM-2312/LM-8035 bracket need
to combine during the installation process and please
refer to the following steps to assemble properly.
Please take out the join bracket and use the attached 4
pcs long screws to fasten this bracket to the main unit
back cover which circled in the right picture.