REMKO MKT 251 - Manual (Page 16)

7 Commissioning
Before every commissioning the air inlet and outlet
openings should be checked for foreign bodies and
the air inlet filter must be checked for dirt. Blocked
or soiled grids and filters must be cleaned immedi-
ately, see "Care and maintenance" chapter.
Cooling mode
1. Switch the unit on with the "POWER" key.
2. Select cooling mode with the "MODE" key.
The "COOL" LED must illuminate.
3. Set the desired target temperature with the
"TIMER/TEMP/ADJUST" key. The selected
target temperature will be shown in the dis-
play. If the fan stage selected is too large or
too small then this can be adjusted with the
"FAN SPEED" key.
Recirculation mode
1. Switch the unit on with the "POWER" key.
2. Select ventilation mode with the "FAN
SPEED" key. The "HIGH/MED/LOW" LED
must illuminate.
REMKO MKT
16