REMKO MKT 251 - Manual (Page 9)

4 Operation
The system can be operated by means of the control panel on the unit or via the standard infrared remote
controller. The functional operation of the keys among themselves is identical, however, the designation can
vary. The batteries must be correctly inserted before the infrared remote control is used.
9
1
10 11 12 13
14 2 3 4 5 6
7 8
Fig. 3: Control panel
Legend
1 On / off "Power" key
2 Operating mode "MODE" key
3 "Fan Speed" key
4 "Timer" key
5 + 6 keys
Temperature/time adjustment
"Timer/Temp Adjust":
5 Higher, 6 lower
7 Display
8 Red malfunction LED:
Reservoir full
An acoustic and optical signal indicates that the
liquid level switch in the internal reservoir has
switched off the operation of the unit. The acoustic
signal ceases after a short time, the LED remains
active.
9 LED operating mode indicator
Green: "Cool" orange: "Dehumidify" yellow: Venti-
late "Fan"
10 Orange LED indicator
Fan stages with "High"/"Med"/"Low" fan speeds
11 Green LED indicator
"Timer"
12 Green LED indicator
"Room Temp"
(If this LED illuminates the current room tempera-
ture is shown in the display ( 7 ))
13 Green LED indicator
Target temperature "Set Temp"
14 Infra-red receiver
The direction of the discharged air via the oscil-
lating fins can be adjusted to fixed or oscillating by
pressing the "AUTO SWING" key.
15 "°C/°F" changeover key
(Only on the remote control)
16 Infrared transmitter
(Only on the remote control)
9