REMKO RXW 350 - Manual (Page 5)

5
Operation
Two to four seconds after the indoor unit has been con-
nected to the power supply, operation can begin.
Inserting batteries into the remote control
Prior to initial operation, the batteries supplied with the
unit (2 type AAA batteries) must be inserted into the re-
mote control.
1. Slide off the cover of the battery slot on the remote
control and insert the batteries.
2. Make sure that the polarity is correct.
Use the labelling in the slot.
3. Close the battery slot again.
The remote control
The air conditioner is operated using the infrared re-
mote control.
A beep indicates that a button has been pressed and
the signal has been correctly received.
4
1
2
10
6
5
7
9
11
3
8
1 ON/OFF button
The unit is switched on with this button.
The settings appear on the display.
2 TEMP UP/DN button
This button is used to decrease the temperature
down to no more than of 16°C or increase the tem-
perature up to 30°C.
3 FAN SPEED button
This button is used to set the desired speed.
There are 4 speeds available:
automatic, low, medium and high.
4 MODE button
This button is used to select the operating mode.
The indoor unit has 5 modes:
Automatic:
In this mode, the unit operates in cooling or heat-
ing mode.
Cooling:
In this mode, the warm room air is cooled down to
the desired temperature.
Dehumidifying:
In this mode, the room is primarily dehumidified
and the set temperature is maintained.
Ventilation:
In this mode, the air in the room is circulated. It is
not possible to select the temperature.
Heating:
In this mode, the warm room air is heated to the
desired temperature.
5 SWING button
This button directly activates the oscillating function
of the fins to improve the air distribution in the room.
6 SLEEPING button
After this button is pressed in cooling mode, the tar-
get temperature automatically increases by 1°C
within one hour and in heating mode, the target
temperature decreases by 1°C within one hour.
7 T-ON button
The unit is programmed to automatically switch on
within the next 24 hour-period with this button.
8 T-OFF button
The unit is programmed to automatically switch off
within the next 24 hour-period with this button.
9 CANCEL button
The timer settings are reset by pressing this button.
10 RESET button (lower)
The remote control settings are reset by pressing
this button.
11 CLOCK button
The time setting is activated by pressing this button.