Scotsman C1448 - Manual (Page 9)

C1448, C1848 D
Air and Water Cooled User Manual
December 2014
Page 8
Uncrate and Set Up
Begin with unpacking the ice storage bin. Remove the
carton, and using part of the carton as a cushion, tip
the bin on its back to remove the skid and attach the
legs or casters.
Note: Turn the leg levelers in all the way and adjust
after the ice machine is on top and in its selected
location.
Return the bin to an upright position. Check the bin
top gasket for gaps and tears, fill any in with food
grade sealant prior to placing the ice machine on the
bin.
Install the bin top adapter if one is required for the
application.
If the ice machine has not been unpacked, do so now.
Remove the carton from the skid. Lift the ice machine
off the skid directly onto the bin.
Note: The machine is heavy! Use a mechanical hoist
if necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and 4 bolts).
Level the bin and ice machine using the adjustment
part of the legs.
Bin Recycling
Many times an ice machine head will be replaced,
while the existing ice storage bin will be reused. This
is an acceptable practice, if some precautions are
taken:
• The used bin must be in good condition. Broken
doors, hinges, or warped walls are reason for
considering a new bin.
• The used bin top edge gasket must be replaced.
Water leaks could occur if the gasket tape is not
replaced.
• The used bin should be the proper size for the ice
machine head.
Lower Light and Switch Panel
This user accessible panel provides important
operational information and duplicates the lights and
switches on the controller. It also allows access to
the On and Off buttons that operate the ice machine.
Sometimes access to the switches should be limited
to prevent unauthorized operation. For that purpose
a fixed panel is shipped in the hardware package.
The fixed panel cannot be opened.
To install the fixed panel:
1. Remove the front panel and remove the bezel.
2. Spread the bezel frame open and remove
original door, insert fixed panel into bezel. Be
sure it is in the closed position.
3. Return bezel to panel and install panel on unit.
Open door to access On
and Off switch buttons.