Scotsman CSW45 - Manual (Page 23)

Repair Information
Water Slide
The water slide is mounted to the front of the
evaporator and diverts water to the reservoir. It is
connected to the evaporator by two screws. Remove
the cutter grid first to get access to it.
Reservoir
The reservoir is located below the evaporator, and is
mounted to the bin liner with two screws.
Water Pump
The water pump is located below the evaporator. It is
mounted to the bin liner with three screws. It also
has a quick-connect electrical plug.
Evaporator Thermistor
This thermistor is a set of two red wires that connect
to the control box. There is a molded portion in one
of the wires with a clip on it. That portion clips onto
the part of the suction line under the middle of the
evaporator that runs front to back.
Compressor
The terminals for the compressor are accessible only
from the back of the unit. Compressor replacement
requires lifting up of the cabinet at the front.
Fan Motor
The fan motor and/or blade is only accessible after
the cabinet has been tilted up.
Component Compartment Access
Note: Chassis does NOT pull out.
Unplug the unit from the power supply. If built in, pull
it out from the counter. Note: The water and drain
lines may have to be disconnected.
1 Remove the front panel.
2. Remove the leveling legs from the cabinet.
3. Remove two screws at the front holding chassis
base to cabinet.
4. Tilt the entire ice maker back far enough to gain
access to the compartment.
July 1999
Page 23
CSW45
Leveling Leg
Screws
Screws