Seaward Apollo 500 - Manual (Page 17)

Comments
Line
This allows the field descriptor for each of the four
comment lines to be changed to show Notes, Asset
Description, Asset Group, Make, Model or Serial
Number or Location as required.
CheckBox
Interval
This field is used to set the frequency of the CheckBox
reminder to none, daily, weekly or monthly.
12. Updating your Firmware
1. Go to www.seaward.co.uk/firmware and save the latest Apollo 500 firmware file on your PC.
2. Power on the unit whilst holding down the F1 button.
3. Press F2 to update via PC.
4. Follow the onscreen instructions.
5. Restart the unit.
You can check the firmware version of your tester by
pressing this icon in the Home screen.
13. Electrical Specification
Earth Continuity
Output Current (Load 2Ω):
Test Voltage (o/c) :
Measuring Range:
Display Range:
Resolution:
Operating Error:
Number of tests as per IEC61557-4:
+/- 200mA DC with ZAP
> 4VDC
0.05Ω – 19.99Ω
0.01Ω – 19.99Ω
0.01Ω
+/-5% + 2 counts
approx 1,500.
Insulation Test
Test Voltages:
Test Current:
Test Voltage Accuracy:
Measuring Range:
Display Range:
Resolution:
Operating Error: ( < 10MΩ )
( > 10MΩ )
Number of tests as per IEC61557-2: 500V and 250V DC
1mA minimum for a load of
1kohm/volt, <2mA into s/c
+20%, -0%
0.10MΩ to 19.99MΩ
0.00MΩ to 19.99MΩ
0.01MΩ
+/-5% +5 counts
+/-10% +5 counts
approx 1,500.
Subsitute Leakage Test
Test Voltages:
Measuring Range:
Display Range:
Resolution:
Operating Error: >25Vac <50Vac
0.20mA to 19.99mA
0.00mA to 19.99mA
0.01mA
+/-10% +2 digits
Protective Conductor Current
Test Voltage:
Display Range:
Measurement Range:
Resolution:
Operating Error:
Frequency Response:
Supply Voltage, maximum load
current 16A
0.01mA to 19.99mA
0.25mA to 19.99mA
0.01mA
+/-5% of reading +/- 3 digits
40Hz to 2.5 kHz