Soundtube SM500i-II - Manual (Page 2)

1. Unpack speaker and
mounting hardware.
2. Choose a secure mounting
sur
strength to reliably hold the
speaker. Note: Bracket
6. Use supplied screw to
connect the safety cable to
one of the inserts on the
rear panel of the speaker.
7. 8.
4. Connect signal wire to
4-pin Euroblock plug. Tighten
unused terminal screws. Use
inside positive and negative
inputs for either voice coil or
distributed systems. For
daisy chaining, use outside
positive and negative
terminals.
3. Slip terminal weather
boot over signal wire. For
environmental applications,
put RTV silicone around
nipple and base when
installation is complete.
11. Select the tap position by
removing the rubber plug on
grille to access rotary switch.
Switch is preset to maximum
tap setting in 70.7 V mode.
Select desired setting and
reinsert rubber plug.
5. Insert 4-pin Euroblock
plug into Euroblock jack on
rear of speaker. Connectors
are keyed for polarity.
Install Instructions For:
SM500i-II, SM500i-II-WX, SM590i-II, SM590i-II-WX speaker
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
SM5 Series
orientation does not matter
for installation of the
mounting bracket.
Terminal weather boot
will seal the enclosure on
rear of speaker.
Line up bracket ribs with
mounting tube slots and
press speaker onto bracket.
Twist clockwise until speaker
clicks. Speaker is now locked
in place.
If speaker is within reach
of the public, or extra security
is desired, install the included
M3x4mm security screw.
10. Make sure knob is loose,
and aim speaker in desired
direction (0 to 90). Tighten
the knob to lock the speaker
in place. FINGER TIGHT IS
SUFFICIENT- DO NOT OVER
TIGHTEN.
To loosen, use included hex
key.
64
32
16 8
4
64
32 16 8
.05 1
2
4
12. Done.
1.
2.
9. Firmly grip speaker and
pull it away from the wall to
rotate to to desired mounting
angle about the mounting
shaft axis. Simply release
speaker back toward the wall
to lock into place.
1.
2.
Connect other end of the
safety cable to a secure
mounting point.