Teac CD-601MKII - Manual (Page 4)

4
TASCAM CD-601MKII
Safety Information
Rack-mounting the Unit
The CD-601MKII can be mounted in a standard 19-inch
rack by using the optional RM-601 rack shelf as shown
below.
This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified
as a class 1 laser product. There is no hazardous
invisible laser radiation during operation because
invisible laser radiation emitted inside of this product
is completely confined in the protective housings.
The label required in this regulation is shown
ແ .
Optical pickup:
Type: KSS-213C
Manufacturer: SONY
Corporation
Laser output: Less than 0.4 mW on the
objective lens
Wavelength: 760 to 800 nm
CAUTION
• DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
• USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
• IF THIS PRODUCT DEVELOPS TROUBLE,
CONTACT YOUR NEAREST QUALIFIED SERVICE
PERSONNEL, AND DO NOT USE THE PRODUCT
IN ITS DAMAGED STATE.
NOTE
• Leave 1U of space above the unit for ventilation.
• Allow at least 10 cm (4 in) at the rear of the unit for
ventilation.
CD-601MKII_Eng.indd 4 3/26/2005 7:39:44 PM