Teac DM-24 Addendum - Manual (Page 15)

TASCAM DM-24 2.0 release notes
15
DM-24 version 2.0—Release notes—Effects (TC Works reverb)
Effects (TC Works reverb)
A new setting has been added to the previous three
settings (
4s
,
16s
and
64s
) for the decay range for the
TC Works reverb internal effector.
This new setting is
1s
, changing the on-screen view-
ing of the decay time settings.
Also, the stereo imaging of the TC Works reverb has
been greatly enhanced in 2.0.
Effects (tap delay)
The external switch (typically a footswitch) can now
be used to set the timing of the delay by tapping in
time with the desired delay interval. See “External switch (footswitch) functionality” on
page 24 for details of how to set up the switch.
Library
New options are now available on all library man-
agement screens.
Deleting library entries
While before, it was only possible to recall entries,
and to overwrite unwanted entries, the new
DELETE
button allows the data in the highlighted library entry
to be deleted. A popup message appears when the
DELETE
button is pressed, asking for confirmation of
the delete action (read-only data cannot be deleted, of
course).
Library safe
In addition to the existing parameters that may be
saved when a snapshot is changed, the library snap-
shot screen now includes options to preserve both
effect settings and effect patching.
Checking the EFFECT Settings box means that the val-
ues chosen for the effects will remain when the new
snapshot is loaded.
Checking the EFFECT Patch box means that the effect
patches and routing to and from the internal effects
are preserved when the new snapshot is loaded.
Undo/redo In addition, there is now an
UNDO/
REDO
button, allowing the last library recall operation
to be undone or redone.