Teac DM-24 Addendum - Manual (Page 22)

22
TASCAM DM-24 2.0 release notes
DM-24 version 2.0—Release notes—Automation
Automation
Touch function
The touch function is used to overwrite and erase
POD, rotary encoder or switch moves. Since these
controls are not touch-sensitive, this is a useful way
to erase previous mix moves on these controls. The relationship between the previous mix moves
and moves made using the touch function is shown
below
To operate the touch function:
1 Enable Global Write mode.
2 Press and hold the
TOUCH
key and while
holding it, operate the non touch-sensitive
control (PODs, rotary encoders or switches)
to begin writing or overwriting at the con-
trol’s current value. While moving the con-
trol, you can release the
TOUCH
key. Write
mode is still enabled for this control.
3 Make a new mix move or end writing manu-
ally by pressing the
REVERT
key.
If a new move is written, the revert action
follows the settings made on the
AUTO MAIN
screen.
UNDO (static)
The
UNDO
key now can be used to undo adjustments
made to a static control during a mix pass, as well as
its previous “undo all mix moves” function.
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec
1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec
-9
Existing Move
Mix Move
Press/Hold
TOUCH
&
Move control
New Move Auto or Manual
Revert
Control
Writing
Revert
Time