Teac DM-24 - Manual (Page 127)

17 – Specifications—Dimensional drawing
TASCAM DM-24 Reference Manual
127
Dimensional drawing
Messages and troubleshooting
This provides a list of the messages that you may see
on the DM-24, which provide information on the
operation that you are performing.
Not all of these messages are error messages.
“Information” messages, i.e. those which pop up
briefly and provide information about a change in
status, etc., are marked with a
●.
“Confirm” messages, where a response may be nec-
essary (usually confirm with the
ENTER key or can-
cel with the cursor keys) are marked with a
✔
.
Error messages demanding action other than a simple
confirmation are shown with a (
✖
), but even these do
not necessarily indicate an error.
TASCAM
93 mm
(3.7 in)
582 mm (22.9 in)
574 mm (22.6 in)
657 mm (25.9 in) t
198 mm (7.8 in)
Action Message Explanation
✔
Flash Write Count
EQ
Library: aaaa
Gate/Expand Library: bbbb
Comp Library: ccccc
Effect Library: dddddd
Snapshot Area 1: eeee
Area 2: fffff
Area 3: gggg
Area 4:
Press ENTER to continue.
The message displayed when the library flash memory usage is checked. The
“aaaa” etc. values are replaced by real numbers (“FLASH Info.” on page 22).
✔
Copy OK?
Press ENTER to confirm,
or a cursor key to cancel. Shown when about to copy parameters in the UTILITY PARAM. COPY screen
(“UTILITY copying” on page 62).
✖
Reboot after
System Data All has been loaded.
Press ENTER to confirm,
or a cursor key to cancel. Shown after ALL System Data has been received (“Bulk transfer of data to the
DM-24” on page 96). The DM-24 should be rebooted. Turn down the volume of
all other devices and press ENTER.
✖
Can’t load data.
Unexpected data type.
Load data type:
[DM-24 SNAPSHOT SNGL]
Press ENTER to continue. Shown if the data type being loaded by MIDI Bulk Dump transfer does not
match the expected type (“Bulk transfer of data to the DM-24” on page 96).