Teac DM-24 - Manual (Page 130)

17 – Specifications—Messages and troubleshooting
130
TASCAM DM-24 Reference Manual
✔
Clear all current automation data?
Press ENTER to confirm,
or a cursor key to cancel. Shown when attempting to clear all current automation memory.
✔
Clear this fader grouping?
Press ENTER to confirm,
or a cursor key to cancel. Shown when the SEL key of a group master is pressed. Pressing ENTER will
clear the group (“Grouping” on page 69).
✔
Clear this fader grouping?
Press ENTER to confirm,
or a cursor key to cancel. Shown when an assigned fader grouping master group’s SEL key is pressed
(“Grouping layers” on page 71). ENTER will clear the group.
✔
Clear this mute grouping?
Press ENTER to confirm,
or a cursor key to cancel. Shown when the SEL key of a group master is pressed. Pressing ENTER will
clear the group (“Grouping” on page 69).
✔
Clear this mute grouping?
Press ENTER to confirm,
or a cursor key to cancel. Shown when an assigned mute grouping master group’s SEL key is pressed
(“Grouping layers” on page 71). ENTER will clear the group
✔
Clock check Results
Current Fs: 48kHz
Sources
Word : 44.1kHz 0.0%
Digi In 1 : Out of Range
Digi In 2 : Unuseable
TDIF1 : 44.1kHz 0.0%
TDIF2 : 44.1kHz 0.0%
TDIF3
: Unuseable
Slot1 : 48kHz + 1.0%
Slot2 : Unuseable
Press ENTER to continue.
A sample popup shown when a clock check is performed (“CLOCK settings” on
page 24).
●
COMP Libraryxxx Recalled
to CHy. The compressor library entry xxx has been successfully recalled, and the set-
tings applied to channel y — “Library functions” on page 99
●
COMP Libraryxxx is Read Only! An attempt is being made to overwrite a read-only compressor library entry
(“Library functions” on page 99).
✔
Confirm LIST Auto Detect?
Press ENTER to confirm,
or a cursor key to cancel. Shown when the on-screen LIST AUTO DETECT button is pressed (“Auto-
detection of devices” on page 81).
✔
Confirm TRA Auto Detect?
Press ENTER to confirm,
or a curser key to cancel. Shown when the on-screen button is pressed to start an automatic search for
transport control devices (“Auto-detection of devices” on page 81).
✔
Copy Ch Fader level->Aux level?
Press ENTER to confirm,
or a cursor key to cancel. From the global aux screens, the channel fader levels are being copied to the
specified aux level (“Aux sends (global)” on page 55).
●
Copy from Ch2 Automation config. Shown in automation setup parameter copy operations
✖
Data Load Error.
(sequence or checksum)
MIDI Bulk Load canceled.
Press ENTER to continue. Shown if the Bulk Data sent to the DM-24 is corrupt or cannot otherwise be
received successfully (“Bulk transfer of data to the DM-24” on page 96).
✔
Delete Automation Bank01?
Press ENTER to confirm,
or a cursor key to cancel. Shown when requesting the deletion of an automation memory bank.
✖
Device is not active. Shown if a device has been selected in the Machine Control List (“Selecting
devices for control” on page 80), but is not switched on or connected or is other-
wise unavailable.
Action Message Explanation