Teac RC-HS20PD v.A - Manual (Page 8)

8
TASCAM RC-HS20PD
3 – Preparations
Connecting to an HS-8
Use the included cable to connect the REMOTE connector
on the rear panel of this unit with the HS-8’s REMOTE
connector.
CAUTION
The REMOTE connector is not an Ethernet (LAN) connector. •
Never connect a cable that is connected to a network to
this unit or an HS-8.
Always turn the HS-8 unit power OFF before connecting •
or disconnecting a cable. Connecting a cable while the
power is ON could cause damage.
Attaching the ferrite core to the
HS-8 power cable
Attach the included ferrite core to the HS-8 power cable
as shown below for the stable operation of this unit.
Using the HS-8 SIGNAL GND
terminal
Depending on the operating conditions, flicker might
appear on the color display of this unit or noise might
be heard in the monitoring sound. Should this occur, use
the SIGNAL GND terminal on the rear panel of the HS-8.
(Please prepare a cable to connect to the SIGNAL GND
terminal. No cable is provided with the unit.)
Setting the HS-8
1 Make the following settings to the HS-8 unit as
necessary.
Online function •
If the online function is set to Enable, this unit’s
ON LINE key is enabled, and on line playback can
be turned ON (on line playback) or OFF (monitor
playback).
If the on line function is set to Disable, this unit’s ON
LINE key is disabled, and sound is always output from
all the output connectors.
For details about setting the online function, see
“Enabling online functions” of “9 – Online functions” in
the HS-8 Owner’s Manual.
Play Mode •
Set the play mode as desired.
In One Take mode, playback stops after playing a
single take. In All Take mode, all the takes in the folder
are played in succession.
For details about play mode settings, see “GENERAL
page” of “6 – Internal Settings and Operations” in the
HS-8 Owner’s Manual.
2 Select the folder to play.
See “Loading folders” of “5 – Projects” in the HS-8
Owner’s Manual.