Teac US-1200 - Manual (Page 25)

TASCAM US-1200
25
5 – Mixer Panel Settings
Resetting the effect settings
Select this to reset all the settings on the EFFECTS page.
CAUTION
After resetting, you cannot restore the previous settings.
1. In the menu bar, Click “File” on a Windows PC or click
“TASCAM US-1200 Mixer Panel” on a Mac to open a
pulldown menu, and click “Effect Reset..."
The following confirmation message will appear.
Windows confirmation message
Mac confirmation message
2. Click the “OK” button in the message window to reset the
effect settings to their default values.
The items reset are as follows.
o COMPRESSOR
THRESHOLD, RATIO, ATTACK, RELEASE, GAIN
o NOISE SUPPRESSOR
THRESHOLD, SUPPRESSION, ATTACK, RELEASE
o DE-ESSER
FREQUENCY, DEPTH
o EXCITER
FREQUENCY, DEPTH
o EQ
GAIN for all frequency bands (LOW, MID, HIGH) and MID
FREQ Q
o REVERB
ROOM TYPE, PRE DELAY, REVERB TIME
NOTE
• Click the “Cancel” button to return to the Mixer Panel
without resetting.
• The Effect Reset function does not change the effect on/
off status or the dynamics effect assignment. Use the Mixer
Reset function to restore these settings to their defaults.
See the effect explanations for the default settings of each
effect.
Resetting the mixer settings
Select this to reset the settings on the MIXER page.
CAUTION
After resetting, you cannot restore the previous settings.
1. In the menu bar, Click “File” on a Windows PC or click
“TASCAM US-1200 Mixer Panel” on a Mac to open a
pulldown menu, and click “Mixer Reset..."
The following confirmation message will appear.
Windows confirmation message
Mac confirmation message
2. Click the “OK” button in the message window to reset the
mixer settings and related settings to their default values.
The items reset and their default values are as follows.
The following items on the INTERFACE page
o LINE OUTPUTS 1-2: mixer output L-R
The following items on the MIXER page
o Dynamics effects: off
o Dynamics effects assignment buttons: off
o Effects send selection buttons (all channels): POST
o SEND knobs (all channels): 127
o SOLO buttons (all channels): off
o MUTE buttons (all channels): off
o Pan sliders (all channels): center (C)
o Channel faders (all channels): 0 dB
o LINK buttons (all channel pairs): off
o Send effect: off
o SEND knob: 127
o RETURN knob: 64
o Master fader: 0 dB
o MON MIX: Center
NOTE
Click the “Cancel” button to return to the Mixer Panel
without resetting.