Teac G-02 - Manual (Page 10)

10
Basic operation
1 2 3 4 3
1
Turn the power on.
The power indicator will light.
0 When the power is turned on, the unit starts preheating the
oscillator to its operating temperature. It takes 15 minutes for
the oscillator frequency to stabilize.
2
Press the MASTER/MENU button for 2 or more seconds
to select the clock source.
The clock source changes each time you press the MASTER/
MENU button for 2 or more seconds.
INT OCXO
The internal OCXO is used for the reference clock.
EXT 10M-IN
The 10 MHz signal input through the EXT IN is used as the ref-
erence clock.
3
Set the clock reference frequency to 44.1 or 48 kHz.
Press the MASTER/MENU button to open the FREQ menu and
use the B and C buttons to set the frequency mode (see page 14).
44 (44.1kHz)
Use for playback of CDs, Super Audio CDs and other 44.1 kHz
sources.
48 (48kHz)
Use for playback of DVDs, DATs and other 48 kHz sources.
(Some DVDs and DATs are recorded at 44.1 kHz. In this case,
use the 44.1 kHz setting.)
0 When using only universal clock (100 kHz or 10 MHz), either
setting is fine.
0 Only use 44EXP or 48EXP for frequencies that are not covered
by the 44 and 48 modes (see pages 12-13).
4
Use the A, B and C buttons to set the frequencies
sent to connected devices (see page 11).
5
On the connected devices, turn clock/word sync ON
(or set to slave mode).
Read the owner’s manual for each device for instructions on how
to set their clock/word sync status properly.
NOTE
0 When this unit is not in use, turn its power off.
0 Settings are retained even when the power is turned off.
0 Once settings have been made, those settings can be used when
the power is turned on again.
Set the frequency mode according to the type of disc to be played
or device being used (see page 14).