Teac KS-T2000 - Manual (Page 12)

Kamesan KS-T2000
12
The Kamesan KS-T2000 can use any standard type of battery:
manganese, alkaline, nickel-cadmium, nickel-hydride or lithium-
ion. Four type 3 (AA) size batteries are required.
In normal use and temperature conditions, a set of alkaline bat-
teries will provide between five and six hours of operation.
In addition, the Kamesan KS-T2000 can accept power from a
suitable power adaptor (described in “Using an AC adapter” on
page 14).
The three-segment LED display by
the power switch (top right of the
front panel) gives the battery status
as shown in the illustration here.
The number of LEDs lit shows the
battery status. When only the bottom orange LED is lit, it is time
to replace the batteries with a new set (30 minutes to 1 hour’s
battery life remains).
If there is no battery life at all, none of the LEDs are lit, and the
batteries should be replaced immediately.
If the unit is not to be used for an extended period of time, remove
the batteries from the unit. Do not leave dead batteries in the unit.
The batteries are contained in a standard battery holder, which
slides out for easy replacement. Additional battery holders can
be purchased and “ready-loaded” with spare batteries for easy
replacement.
Batteries and power
Checking the batteries
Replacing the batteries
GOOD > 5hrs (green)
FAIR 2–5hrs (green)
REPLACE 0.5–1hr (orange)