Teletronics EZMesh - Manual (Page 19)

User Guide - EZMesh Full Duplex Mesh Network Access Point
Step 2. Change PC IP address to 192.168.1.XXX Subnet mask: 255.255.255.0
Step 3. Access MeshAP via WAN Ethernet Port
Make sure the Ethernet cable is properly connected to both MeshAP - WAN
Ethernet Port and PC - Ethernet Port. (Connect via PoE Injector)
Note: Please review the Hardware installation Guide for more information.
Step 4. Open a Web Browser and type 192.168.1.8 to access the MeshAP Access Point.
Step 5. User Name: admin
Password: admin
Click "OK
Wireless LAN Access
Step 1. Make sure the MeshAP unit is Powered On and Ready. Once it is powered on, it
takes about 35 seconds for the MeshAP unit to completely get booted and be ready
for service and configuration.
Use wireless WLAN utility application on PC to scan for SSID: mymesh. Make
sure the SSID: mymesh unit has the correct Mac address.
TELETRONICS INTERNATIONAL, INC. - 15 -