Teletronics EZMesh - Manual (Page 46)

User Guide - EZMesh Full Duplex Mesh Network Access Point
Setup Trunk and Native VLAN Mode
Step 1. Login to the Ethernet/VLAN
Step 2. Check “Trunk and Native VLAN” radio button under the VLAN Ethernet
Mode
Step 3. Click Save Setting and Apply
Pure Mode
Pure Trunk - Only tagged (VLAN IDs and priority included) frames entering the
Ethernet port will be accepted. Egress frames will exit the Ethernet port unaltered.
If the frame leaving the Ethernet port contains a VLAN tag, it will be transmitted
with that same tag. If the frame leaving the Ethernet port does not contain a VLAN
tag, the frame with be transmitted without a tag. In this mode, the MeshAP must
be connected to a VLAN capable device and the port on that device must be
configured as a Trunk port.
Setup Pure Mode
Step 1. Login to the Ethernet/VLAN
Step 2. Check “Pure” radio button under the VLAN Ethernet Mode
TELETRONICS INTERNATIONAL, INC. - 42 -