Thinklogical SDIXtreme 3G and 3G+ Manual - Manual (Page 9)

Revision E 9 July 2012
Part 1: Hardware
Contents
When you receive your Thinklogical® SDI Xtreme 3G, you should receive the following items:
• SDI Xtreme 3G Hardware
• 5VDC Power Cords – PWR-000022-R (3G, 3G+)
• AC power cord, PWR-000006-R (International connections may differ) – Qty 2 (3G+ Rack-
mount Only)
• Product Manual CD
• Product Quick-Start Guide
All physical connections to the product use industry-standard connectors.
SFP+ Modules
Small Form-factor Pluggable modules are short-wavelength transceivers designed for use in bi-
directional fiber-optic channel links. Each SFP module is hot-pluggable and operates on 3.3VDC.
Each Tx and Rx contains SFP+ modules that serve as the fiber-optic couplers for the fiber cables
to and from the Thinklogical® Tx and Rx units.
Always use dust caps to protect against damage when a fiber optic connector is not
attached to its coupling device (fiber optic equipment, bulkheads, etc.)
Figure 1: SFP+ Module Figure 2: It is good practice to install
dust plugs in unused SFP+s.
Dust Plug