Tri Tool 236B Single Point User Manual
Page 14
Advertising
14
TRI TOOL INC.
92-1333 : Rev. 110404
FEED ADJUSTMENT
Put the gearbox into neutral.
SETTING THE FEED DIRECTION
Select the proper hole location on the position index plate and the actuator arm for
the required feed.
Set the feed direction by pulling out the knob (for feeding toward the mandrel), in
the center position (for neutral or no feed) or by pushing in the knob (for feeding
away from the mandrel).
Feed System Set-Up
COUNTERBORING FUNCTION
Lock the tool slide in the flat position.
Replace the tool holder and the Insert with the counterbore tool bit.
Insure that the cutting edge is facing out from the center.
A
B
1
3
4
2
Index Plate
Actuator Arm
Feed Knob
Feed In
Neutral
Feed Out
Advertising