Tri Tool 236B Single Point - Manual (Page 16)

16
TRI TOOL INC.
92-1333 : Rev. 110404
Turn the motor on.
Let the machine rotate very slowly for one revolution to verify that the tool bit clears
the ID of the pipe.
Adjust the tool bit into the cutting position, use the manual feed knob on the tool
slide.
Tighten the dovetail slide lock screw in the tool block when desired tool bit position
has been achieved.
This screw must be loosened and re-tightened whenever the dovetail slide
requires repositioning.
When it is not securely tightened, the tool bit may walk out of the cut.
Plunge cut to desired depth.