Tri Tool 308 Tube Squaring - Manual (Page 10)

10
TRI TOOL INC.
92-0628 : Rev. 961122
CAUTION:
Insert the tool bit(s) into the slot(s) in the cutting head.
The cutting edge of the tool bit(s) must be located on the radial centerline.
Do NOT install the tool bit(s) backwards.
Tighten the set screws to secure the tool bit(s) to the cutting head.
Adjust the counterbore tool bit radially to control counterbore diameter.
Adjust the bevel tool bit radially to control the counterbore depth to the bevel
relationship
INSTALLING THE COLLET
Mount the desired Adapter Kit onto the front of the Model 308. Attach by using the
(6) six cap screws from the back of the main housing.
If the Collet Adapter Kit has been attached to the front of the Model 308:
Select the desired collet size for the pipe or tube to be worked on.