Venstar T0051FS - Manual (Page 9)

Page 8
Press
Press
Press the ON/OFF button. While holding the ON/OFF,
press the WARMER button for two seconds to enter
time period programming.
Continued
ON/OFF
ON/OFF
78
C OOL
78
68
C OOL
H EAT
To maximize energy savings, the program allows for a day to be broken into
four time periods with every day of the week sharing the same program. For each
time period, you may choose to have a unique setpoint or simply use the
unoccupied setpoints. If four different time periods are not required, then multiple
time periods may be set to the same start time.
S
MART T EMP - When a time period is set to OFF, unoccupied settings will be
used for that period. During unoccupied operation, the large numbers change
from displaying the setpoint to displaying the room temperature and the degree
icon will flash. If a guest enters the room and presses the WARMER or COOLER
button, the room temperature will be accepted as the setpoint and then can be
raised or lowered. This setpoint will remain in effect until the start of the next time
period. This enables the guest to maintain control over the room temperature
(within setpoint limits), while maximizing energy savings.
Note: These unoccupied setpoints are not used when the dry contact is
asserted. To adjust those setpoints see page 14, steps 5 & 6.
ON/OFF
Programming Occupied & Unoccupied Periods
Adjust the cooling set-
point for unoccupied
periods.
(35 - 99, OF )
Adjust the heating set-
point for unoccupied
periods.
(OF, 35 - 99 )