Installation – Desa CDR3924NT User Manual

Page 8

Advertising
background image

www.desatech.com

113183-01D

8

INSTALLATION

NOTICE: This heater is intended

for use as supplemental heat.

Use this heater along with your

primary heating system. Do not

install this heater as your pri-

mary heat source. If you have a

central heating system, you may

run system’s circulating blower

while using heater. This will help

circulate the heat throughout the

house. In the event of a power

outage, you can use this heater

as your primary heat source.

WARNING: Installation and

repair should be done by a

qualified service person. The

appliance should be inspected

before use and at least annu-

ally by a professional service

person. More frequent cleaning

may be required due to exces-

sive lint from carpeting, bedding

material, etc. It is imperative that

control compartments, burners

and circulating air passageways

of the appliance be kept clean.

WARNING: Before installing

in a solid fuel burning fireplace,

the chimney flue and firebox

must be cleaned of soot, creo-

sote, ashes and loose paint by a

qualified chimney cleaner. Creo-

sote will ignite if highly heated. A

dirty chimney flue may create and

distribute soot within the house.

Inspect chimney flue and firebox

for damage. If damaged, repair

flue before operating heater.

WARNING: Seal any fresh

air vents or ash clean-out doors

located on floor or wall of fire-

place. If not, drafting may cause

pilot outage or sooting. Use a

heat-resistant sealant. Do not

seal chimney flue damper.

WARNING: Never install the

heater

• in a bedroom or bathroom

• in a recreational vehicle

• where curtains, furniture,

clothing or other flammable

objects are less than 42 inches

from the front, top or sides of

the firebox opening

• in high traffic areas

• in windy or drafty areas

CAUTION: This heater creates

warm air currents. These currents

move heat to wall surfaces next

to heater. Installing heater next

to vinyl or cloth wall coverings or

operating heater where impurities

(such as, but not limited to, to-

bacco smoke, aromatic candles,

cleaning fluids, oil or kerosene

lamps, etc.) in the air exist, may

discolor walls or cause odors.

IMPORTANT:

Vent-free heaters add moisture to

the air. Although this is beneficial, installing heater

in rooms without enough ventilation air may cause

mildew to form from too much moisture. See Air

for Combustion and Ventilation, page 5.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP)

for your unit. If your gas supply is not correct, do

not install fireplace. Call dealer where you bought

fireplace for proper type fireplace.

WARNING: This appliance

is equipped for (natural or pro-

pane/LP) gas. Field conversion

is not permitted.

Advertising