Verilink PRISM 3010 Dual DSX-1 (34-00250.2) Product Manual - Manual (Page 2)

ii
Copyright
Notice
Copyright © 1999 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or about its products or
services. Verilink’s sole warranty is contained in its product warranty. The end-user documentation is
shipped with Verilink’s products and constitutes the sole specifications referred to in the product war-
ranty. Verilink has made reasonable efforts to verify that the information contained herein is accurate,
but Verilink assumes no responsibility for its use or for any infringement of patents or other rights of
third parties that may result. The customer is solely responsible for verifying the suitability of Ver-
ilink’s products for its use. Specifications are subject to change without notice.
Manual reorder # 34-00250
2
nd
Edition, May 1999
Trademarks
Verilink and the Verilink logo are registered trademarks of Verilink Corporation.
Any other named products herein are trademarks of their respective companies.
FCC
Requirements
This equipment has been tested and found to comply with the limits for a Class A digital device, pursu-
ant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equip-
ment in a residential area is likely to cause harmful interference in which case the user is required to
correct the interference at his own expense.
Shielded cables must be used to ensure compliance with the Class A FCC limits.
Caution: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment complies with Part 68 of the FCC rules. On the rear or bottom of this unit is a label that
contains the FCC registration number and other information. If requested, provide this information to
the telephone company. The following instructions are provided to ensure compliance with FCC Rules,
Part 68.
1 All direct connections to network lines must be made using standard plugs and jacks.
2 The following information may be required by the local telephone company when applying for leased
line facilities.
T1
3 If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until it is
learned whether the source of trouble is the equipment or the telephone line. If the equipment needs
repair, it should not be reconnected until it is repaired.
4 The unit has been designed to prevent harm to the network. If the telephone company finds that the
equipment is exceeding tolerable parameters, it can temporarily disconnect service. In this case, the
telephone company provides advance notice, if possible.
5 Under FCC rules, no customer is authorized to repair this equipment. This restriction applies
regardless of the warranty status.
6 If the telephone company alters its equipment in a manner that affect the use of this device, it must
provide warning so that the customer can arrange uninterrupted service. The customer will be advised
of the right to file a complaint with the FCC.
✍ ✍
Port ID SOC FIC USOC Jack
1.544 Mbps (SF)
1.544 Mbps (SF) (B8ZS)
1.544 Mbps (ESF)
1.544 Mbps (ESF)
(B8ZS) 6.0 N 04DU9-BN
04DU9-DN
04DU9-IKN
04DU9-ISN RJ-48C