Viante CUC-25PM Pasta Maker Instruction Manual - Manual (Page 11)

10
Dismantling Instruction
Step 1 - Unlocking and removing the
lid
Ensure the switch on the motor base is in the ‘off
‘position before switching the power off at the
power outlet and disassembling the appliance.
To unlock the lid of the mixing chamber, place
one hand on the rear of the motor base as
support. Use your thumb on your other hand to
push the indent of the mixing chamber lid lock.
While pushing in, lift the chamber lock ‘UP’.
Remove the lid from the mixing chamber.
Step 2 - Removing the slider
To completely remove the slider from the Pasta
Maker, pull the slider out until the release
button is exposed.
Once the release button is exposed, press down
on the release button while pulling the slider out.
The mixing chamber will not be able to be
removed unless the slider has been removed
first.
Step 3 - Disassembling the mixing
chamber
To remove the mixing chamber, press down on
the mixing chamber release button.
While pressing the mixing chamber release
button, pull the mixing chamber out of the motor
base.
During the extruding process, the mixing
chamber may move forward from the motor base
due to the force of the pasta dough pressing
against the pasta disc. If this happens push the
mixing chamber back into the motor body and
then press the mixing chamber release button
to remove the mixing chamber from the motor
base.
Remove the steel rod from inside the mixing
paddle.
Lift the mixing paddle out of the mixing chamber
by pulling it up.