Viante CUC-25PM Pasta Maker Instruction Manual - Manual (Page 13)

12
How To Clean & Care
Cleaning the motor base
Wipe the motor base with a clean, damp cloth
after each use. Dry thoroughly with a soft, clean
cloth.
Use a dry soft bristle pastry brush to clean any
excess flour off the motor base.
Cleaning the pasta discs, extruding
and mixing chambers, mixing paddle,
spiral extruding rod, slider, disc holder,
measuring spoon and lid
Use the pointed end of the cleaning tool
provided to remove excess pasta dough from
these parts, especially the fine holes of the
pasta discs.
Hand wash parts in warm to hot, soapy
water using a mild detergent. Rinse and dry
thoroughly.
The mixing chamber, plastic mixing paddle,
spiral extruding rod, pasta discs and the slider
can also be washed in the dishwasher (top shelf
only). It is not recommended to put the steel rod
into the dishwasher.
Food stains and odours
Foods such as carrot or roasted capsicum
may leave a stain on plastic parts whilst other
foods such as garlic may leave a strong odor.
To remove either, soak the plastic parts for 5
minutes in 2 litres of water with ½ cup lemon
juice added. Rinse and wash as normal.
SUGGESTION: To remove stubborn dough, use
a piece of excess dough to rub over areas
where pasta dough or flour has stuck to
the surface.
The mixing chamber may need to be left
overnight to completely dry.
CAUTION: DO NOT IMMERSE THE MOTOR
BASE, POWER CORD OR POWER PLUG IN WATER
OR ANY OTHER LIQUID.
Do not use a scourer or abrasive cleaners as
these will scratch the plastic surface.
CAUTION: TO PREVENT DAMAGE TO THE
APPLIANCE DO NOT USE ALKALINE CLEANING
AGENTS WHEN CLEANING. ONLY USE A SOFT
CLOTH AND MILD DETERGENT.
CAUTION: DO NOT PUT ANY PART OF
THE PASTA MAKER IN THE MICROWAVE OVEN.
WARNING: TH E MIXING PADDLES DURING
PROCESSING ARE TURNING EXTREMELY FAST, DO
NOT PLACE YOUR HANDS INTO MIXING CHAMBER
UNTIL THE MIXING PADDLE HAS STOPPED.