Visara iCON-XT Installation - Manual (Page 28)

3-6 707097-001
ICON-XT Server - Installation and Maintenance Manual
Accessing the SCA Drive Tray and Installing a HDD
To install the SCA drive into the chassis, you need to first remove the SCA drive tray
from the chassis.
Procedures
1. Press the release tab located on the drive tray door to release the drive tray from its
locking position as shown below:
1
2 a
2b
2. Pull the drive tray door upward and then pull the SCA drive tray out from the
chassis.
3. Mount a hard drive in the drive tray as shown below:
3 a
3b
4. If this is a replacement drive, mount the new drive in the drive tray using the screws
currently securing the drive being replaced.