Westermo MDI-112-F4G - Manual (Page 85)

81
After created the VLAN, the status of the VLAN will remain in Unused until you
add ports to the VLAN.
Note: Before you change the management VLAN ID by Web and Telnet,
remember that the port attached by the administrator should be the member
port of the management VLAN; otherwise the administrator can’t access the
switch via the network.
Note: Currently the switch only support max 255 group VLAN.
Static VLAN Configuration
You can see the created VLANs and specify the egress (outgoing) port rule to be
Untagged or Tagged here.
Static VLAN Configuration table. You can see that new VLAN 3 is created. VLAN
name is test. Egress rules of the ports are not configured now.
-- : Not available
U: Untag: Indicates that egress/outgoing frames are not VLAN tagged.
T : Tag: Indicates that egress/outgoing frames are to be VLAN tagged.
Steps to configure Egress rules: Select the VLAN ID. Entry of the selected VLAN
turns to light blue. Assign Egress rule of the ports to U or T. Press Apply to apply
the setting. If you want to remove one VLAN, select the VLAN entry. Then press
Remove button.