Westermo DR-270 - Manual (Page 19)

19 6622-2241 • 29000589, REV.A
WWAN
PRIMARY
WIFI
SECONDARY
WWAN
SECONDARY
WIFI
PRIMARY
9-36VDC, 3,5A MAIN AUX. SERIAL 0 LAN3 LAN2 LAN1 LAN0
DSL
DR-270
DSL Router
POWER NET SIM DAT
SIM 1
SIM 2
3G/GPRS
WIFI DSL 0 1 2 3
LAN SIGNAL
Step-by-step guide to configure a DSL-connection
using the web interface
Power Connection
ADSL
connection (RJ-11)
PC/Ethernet
connection (RJ-45)
Step 1 – Power-up the unit and wait for it to become ready
Connect the DR-270 to the DSL-network using the RJ-11, connect an RJ-45 cable from
one of the four Ethernet-ports to your PC, and then connect the unit to an appropriate
PSU and power it up.
The unit will start to negotiate the DSL-connection after approximately 15 – 20 seconds,
please note that the default settings might not be appropriate for your specific connec-
tion. Continue reading in order to assure that you have a valid setup.
Step 2 – Configure your PC
Make the following changes in your PC.
IP address 192.168.2.100*
Netmask (Ethernet ports) 255.255.255.0
Gateway 192.168.2.200
Preferred DNS server 192.168.2.200
* Can be any address in the 192.168.2.0-255-range except 192.168.2.200.
Note! If you are unsure or unable to change the above – consult your network
administrator.