ACTi Bullet Camera (E44~E46) on Tilted Wall with Integrated Bracket - Manual (Page 6)

www.acti.com
Installation Guide
6
b. If necessary, adjust the bracket position and then tighten the lock screw to lock
its position.
3. Mark and drill the location of the screw holes and cable hole, if necessary.
NOTE: Depending on the surface where you will install the camera, it may be necessary to
drill three (3) holes and use the supplied screw plugs.
Step 2: Install and Connect the Camera
1. Connect the Ethernet connector of the camera and the network to each side of the bundled
2-sided female type connector. If the cables will pass through the wall , push the cable
through the hole on the wall.
Ethernet cable
of the camera
Ethernet cable
from the network
2-Sided Female
Type Connector