ACTi TCD-2100 User Manual
Page 12
TCD-2100 Hardware Manual
Via RS-232 Connection
Terminal Block
Wire Mapping
Pin Number / Label
IP Device Pin
Camera Pin
1
TX +
TX +
RX
2
TX -
3
RX+
RX +
TX
4
Rx-
NOTE:
The pins/cables of the analog camera may be labeled differently depending on
the location or country where the camera is purchased. For example, some devices may
have
TX -
pin labeled as "A” or “485 -”, etc. Refer to the camera documentation or
contact the manufacturer to verify the corresponding pin labels and ensure proper wiring
connection.
CAUTION:
Incorrect wiring may cause damage to the connected devices.
DISCLAIMER:
ACTi will not be responsible for any damage caused by improper wiring.
3.
Connect a ground wire to one of the GND terminal pins of the IP device (via Power or DI/P
terminals) to complete the connection.