ACTi TCD-2100 - Manual (Page 8)

www.acti.com
TCD-2100 Hardware Manual
8
4) Power LED
The LED will light up after device has successfully completed the boot process
5) Serial Port LED
LED will light up when serial port is active
6) Power Input
Connect the power adaptor here if your power input is DC12V.
7) Reset Button
Step 1: Switch off IP device by disconnecting the power cable
Step 2: Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.)
Step 3: Reconnect the power cable while continuing to hold the reset button. The red
Power LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for
another second and turn off again. By this time the reset to default operation is already
completed. This will take around 20 seconds from power up. You may then release the
reset button. This length of time fluctuates slightly with the environment. The Power LED light
will come back on and stay on after a few more seconds. The unit will start up with factory
default settings automatically.
PIN NAME DESCRIPTION
1 12V DC Power Input
2 GND Ground Pin