ACTi TCD-2100 - Manual (Page 15)

www.acti.com
TCD-2100 Hardware Manual
15
Use the default IP address of the device
If there is no DHCP server in the given network, the user may have to manually assign the IP
addresses to both the PC and the device to make sure they are in the same network segment.
When the device is plugged into the network and it does not detect any DHCP services, it will
automatically assign itself a default IP:
192.168.0.100
Whereas the default port number would be 80 . In order to access that device, the IP address of
the PC has to be configured to match the network segment of the device.
Manually adjust the IP address of the PC
In the following example, based on Windows 7, we will configure the IP address to
192.168.0.99 and set Subnet Mask to 255.255.255.0 by using the steps below:
1 2
3 4