Epson 10020 - Manual (Page 41)

Then press any key. The DISKCOPY program copies the
contents of the Startup diskette to the computer’s memory,
and then you see the following:
Insert TARGET diskette in drive A:
Press any key when ready . . .
4. Remove the Startup diskette and insert a blank diskette
(which is to be the target) in the drive. Then press any key.
If the diskette is not formatted, the DISKCOPY program
formats it. (Formatting prepares a diskette to store data and
is described in Chapter 3.) Then the program begins
copying the data from the computer’s memory to the
formatted diskette. When the copy is complete, you see
this prompt:
Copy another diskette (Y/N)?
5. Press Y so you can make a copy of the Operating 1 diskette.
Again, you see the prompt to insert the source diskette.
6. Remove the copy of the Startup diskette, which you just
made, and insert the Operating 1 diskette in the drive.
Then press any key. Continue following the prompts on
the screen to make a copy of this diskette, as you did the
Startup diskette.
7. Repeat the procedure to copy the Operating 2 diskette and
then the Reference diskette.
8. When you finish copying the last diskette and the Copy
another diskette (Y/N)? prompt appears, press
N to return to the MS-DOS command prompt.
1-24 Setting Up Your System