Epson 10020 - Manual (Page 46)

WARNING
Do not reset the computer to extra Do not the program unless you have
to Same application progress classify and store new data
when you exit the program. If you reset the computer
without properly exiting the program, you may lose data
To reset the computer, MS-DOS must be either on the hard
disk or on a diskette in drive A; so if you have the Apex 100,
insert the Startup diskette in drive A.
There are three ways to reset. Because each is more powerful
than the last, try them in the order listed here:
1. If you are using MS-DOS, hold down Ctrl and Alt and press
the Del key. The screen goes blank for a moment and then
the computer should reload MS-DOS. If it doesn’t, try the
second method.
2. Press the RESET button on the front panel. This method
works even when the keyboard does not respond to your
commands. if this does not correct the problem, try the
third method.
3. Remove any diskette from the diskette drive(s). Turn
off the computer and wait five seconds. If you have the
Apex 100, insert the Startup diskette in drive A. Then
turn the power back on.
Turning Off the Computer
Before turning off your computer, be sure to save your data and
exit the program you are using. Then remove any diskettes
from the disk drives.
Turn off the computer first and then turn off the monitor and
any peripherals.
Using Your Computer 2-5