Ericsson LBI-39224 - Manual (Page 142)

LBI-39224
3-112
Console Channel Configuration List dialog box
Send
Choose the Send button to send the console channel configuration data
to the respective interface module. This procedure must be performed
before the interface module will operate with the new configuration.
Only configured and configured-and-active (C and C/A prefixes)
configurations may be sent. All configuration data is sent to the MOM
Controller Board; the Audio configuration is sent directly out from
there to the respective interface module Controller Board. A "Send to
Console Successful" message will be received to confirm that the data
was received by the interface module Controller Board. Bus Slot
configuration data is compared to the current configuration at the
CEC/IMC Manager; if different, it is sent to the MOM Controller
Board (if not, no further action is taken by the system) and when the
MOM Controller Board receives this new data it will send an
acknowledgment message back to the CEC/IMC Manager, which will
then display the confirmation box: "Do you want to activate TDM Bus
Slots? OK - will cause all CTRL boards to reset." Choose
OK to
activate TDM Bus Slots (resetting Controller Boards) with the new Bus
Slot configuration data, choose
Cancel to not activate TDM Bus Slots
with the new Bus Slot configuration data (keeping the previous
configuration) and return to the
Console Channel Configuration List
dialog box.
Close
Choose the Close button to exit the
Console Channel Configuration List dialog box and return to the
CEC/IMC Manager main window. Any "**" prefixed consoles
appearing in the Configured/Active Consoles list box will be removed
and returned to the Configurable Consoles list box.
3.11.2 Console User Profile Configuration
This option is used to configure each console in the system and its
associated user profiles. Ten different profile set-ups may be
configured for each console, each having a unique personality. These
setups are done from the
Console User Profile Configuration dialog
box, Figure 27. From the CEC/IMC Manager menu bar select
Configure System / Console Configuration / User Profile to display
the Console User Profile Configuration dialog box.