Is-is route redistribution configuration example – H3C Technologies H3C S12500-X Series Switches User Manual
Page 175
161
293B
IS-IS route redistribution configuration example
562B
Network requirements
As shown in
1047H
Figure 41
, Switch A, Switch B, Switch C, and Switch D reside in the same AS. They use IS-IS
to interconnect. Switch A and Switch B are Level-1 routers, Switch D is a Level-2 router, and Switch C is a
Level-1-2 router.
Redistribute RIP routes into IS-IS on Switch D.
Figure 41 Network diagram
563B
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure basic IS-IS:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] is-level level-1
[SwitchA-isis-1] network-entity 10.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] isis enable 1
[SwitchA-Vlan-interface100] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis 1
[SwitchB-isis-1] is-level level-1
[SwitchB-isis-1] network-entity 10.0000.0000.0002.00
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] isis enable 1
[SwitchB-Vlan-interface200] quit
# Configure Switch C.
<SwitchC> system-view
[SwitchC] isis 1