H3C Technologies H3C S12500-X Series Switches - Manual (Page 40)

31
Tasks at a glance Remarks
(Required.) Configuring a domain ID for a switch
When statically building a fabric, you must
manually configure a domain ID for each
switch.
(Optional.) Configuring the mapping between the N_Port WWN
and an FC address
N/A
(Optional.) Configuring the fabric timers N/A
(Optional.) Configuring RSCN aggregation N/A
(Optional.) Configuring and obtaining FC4 information of nodes N/A
Building a fabric dynamically
Tasks at a glance Remarks
(Required.) Configuring a VFC interface N/A
(Required.) Enabling or disabling the fabric configuration
function
To dynamically build a fabric, you must
enable the fabric configuration function.
(Optional.) Setting the switch priority
Principal switch selection relies on the
switch priority.
(Optional.) Configuring the allowed domain ID list N/A
(Optional.) Configuring a domain ID for a switch
When dynamically building a fabric, you
can configure desired domain IDs for
switches.
(Optional.) Configuring the mapping between the N_Port WWN
and an FC address
N/A
(Optional.) Configuring the fabric timers N/A
(Optional.) Configuring the fabric reconfiguration N/A
(Optional.) Configuring a VFC interface to reject incoming RCF
requests
N/A
(Optional.) Configuring RSCN aggregation N/A
(Optional.) Configuring and obtaining FC4 information of nodes N/A
Enabling or disabling the fabric configuration
function
After being enabled with the fabric configuration function, FCF switches exchange messages to select the
principal switch. Then the principal switch dynamically assigns domain IDs to all switches in the fabric.
Therefore, to dynamically build a fabric, you must enable the fabric configuration function on switches.
To statically set up a fabric, you must disable the fabric configuration function on switches and manually
configure domain IDs for the switches.
To enable or disable the fabric configuration function: