H3C Technologies H3C S10500 Series Switches - Manual (Page 115)

100
To do… Use the command… Remarks
Enable OSPF NSR ospf non-stop-routing
Optional
Disabled by default.
Configuring BFD for OSPF
OSPF supports the following BFD detection methods:
• Control packet bidirectional detection, which requires BFD configuration to be made on both OSPF
routers on the link.
• Echo packet single-hop detection, which requires BFD configuration to be made on one OSPF router
on the link.
Configuring control packet bidirectional detection
Follow these steps to enable BFD control packet bidirectional detection on an OSPF interface:
To do… Use the command… Description
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Enable BFD control packet bidirectional
detection on the interface
ospf bfd enable
Required
Not enabled by
default
NOTE:
•
One network segment can only belong to one area.
• Both ends of a BFD session must be on the same network segment and in the same area.
Configuring echo packet single-hop detection
Follow these steps to enable BFD echo packet single-hop detection on an OSPF interface:
To do… Use the command… Description
Enter system view system-view —
Configure the source address of echo packets bfd echo-source-ip ip-address
Required
Not configured by
default
Enter interface view
interface interface-type
interface-number
—
Enable BFD echo packet single-hop detection
on the interface
ospf bfd enable echo
Required
Not enabled by
default