H3C Technologies H3C S10500 Series Switches - Manual (Page 327)

312
To do… Use command to… Remarks
Configure the maximum number
of redistributed Level 1/Level 2
IPv6 routes
ipv6 import-route limit number
Optional
The default varies with
devices.
Configure the filtering of
outgoing redistributed routes
ipv6 filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name | route-policy
route-policy-name } export [ protocol
[ process-id ] ]
Optional
Not configured by
default
Enable route leaking
ipv6 import-route isisv6 level-2 into level-1
[ filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name | route-policy
route-policy-name } | tag tag ] *
Optional
Not enabled by default
Specify the maximum number of
equal-cost load balanced routes
ipv6 maximum load-balancing number
Optional
8 by default
NOTE:
•
The ipv6 filter-policy export command is usually combined with the ipv6 import-route command. If no
protocol is specified for the ipv6 filter-policy export command, routes redistributed from all routing
protocols are filtered before advertisement. If a protocol is specified, only routes redistributed from the
routing protocol are filtered for advertisement.
• For information about ACL, see ACL and QoS Configuration Guide.
• For information about routing policy and IPv6 prefix list, see the chapter “Routing policy configuration.”
Configuring BFD for IPv6 IS-IS
Bidirectional forwarding detection (BFD) provides a mechanism to quickly detect the connectivity of links
between IPv6 IS-IS neighbors, thus to improve the convergence speed of IPv6 IS-IS.
Follow these steps to configure BFD for IPv6 IS-IS:
To do… Use command to… Remarks
Enter system view system-view ––
Enable an IS-IS process and enter
IS-IS view
isis [ process-id ] —
Configure the network entity title
for the IS-IS process
network-entity net
Required
Not configured by default
Enable IPv6 for the IS-IS process ipv6 enable
Required
Disabled by default
Return to system view quit ––
Enter interface view
interface interface-type
interface-number
––
Enable IPv6 for an IS-IS process on
the interface
isis ipv6 enable [ process-id ]
Required
Disabled by default
Enable BFD on the interface isis ipv6 bfd enable
Required
Not enabled by default