H3C Technologies H3C MSR 5600 - Manual (Page 175)

162
Operation Description XML example
edit-config: create
Creates a specified target. To
use the create attribute in the
edit-config operation, you must
specify the operation target.
• If the table supports target
creation and the specified
target does not exist, the
operation creates and then
configures the target.
• If the specified target exists,
a data-exist error message is
returned.
The XML data format is the same as the edit-config
message with the merget attribute. Change the
operation attribute from merge to create.
edit-config:
replace
Replaces the specified target.
• If the specified target exists,
the operation replaces the
configuration of the target
with the configuration
carried in the message.
• If the specified target does
not exist, the operation is not
conducted and error
messages are not returned.
The syntax is the same as the edit-config message with
the merget attribute. Change the operation attribute
from merge to replace.
edit-config:
remove
Removes the specified
configuration.
• If the specified target has
only the table index, the
operation removes all
configuration of the
specified target, and the
target itself.
• If the specified target has the
table index and
configuration data, the
operation removes the
specified configuration data
of this target.
• If the specified target does
not exist, or the XML
message does not specify
any target, a success
message is returned.
The syntax is the same as the edit-config message with
the merget attribute. Change the operation attribute
from merge to remove.