H3C Technologies H3C MSR 50 - Manual (Page 30)

21
Step Command Remarks
123. Connect the workgroup
bridge mode to the wireless
network.
client-mode connect Optional.
124. Disconnect the workgroup
bridge from the wireless
service.
client-mode disconnect Optional.
Displaying and maintaining workgroup bridge
Task Command Remarks
Display workgroup bridge
configuration and connection
status.
display wlan client-mode radio [ |
{ begin | exclude | include }
regular-expression ] Available in any view.
Display the wireless services
scanned by the workgroup bridge
and the signal quality.
display wlan client-mode ssid
[ ssid ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
WLAN access configuration examples
WLAN access configuration example
Network requirements
As shown in Figure 7 , enable the client to access the internal network resources at any time. The AP
provides a plain-text wireless access service with SSID service. 802.11g is adopted.
Figure 7 Network diagram
Configuration procedure
1. Configure the fat AP:
# Create a WLAN BSS interface.
<AP> system-view
[AP] interface wlan-bss 1
[AP-WLAN-BSS1] quit
# Configure a clear type WLAN service template, with no authentication.
[AP] wlan service-template 1 clear
[AP-wlan-st-1] ssid abc
[AP-wlan-st-1] authentication-method open-system
[AP-wlan-st-1] service-template enable
L
A
N
Segment