H3C Technologies H3C MSR 50 - Manual (Page 79)

70
SVP service configuration example
1. Network requirements
As shown in
Figure 31 , the fat AP is connected to the Ethernet and has WMM enabled.
On the fat AP, SVP packets are assigned to the AC-VO queue. To guarantee the highest priority for
the AC-VO queue, ECWmin and ECWmax are set to 0 for the AC-VO queue.
Figure 31 Network diagram
2. Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.11e priority of received packets for priority
mapping.
<Sysname> system-view
[Sysname] interface wlan-bss 1
[Sysname-WLAN-BSS1] qos trust dot11e
[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority
mapping.
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] qos trust dot1p
[Sysname-Ethernet1/0] quit
# Create a clear-type WLAN service template, configure its SSID as market, configure its
authentication method as Open System, and then enable the WLAN service template.
[Sysname] wlan service-template 1 clear
[Sysname-wlan-st-1] ssid market
[Sysname-wlan-st-1] authentication-method open-system
[Sysname-wlan-st-1] service-template enable
# Configure the radio interface WLAN Radio 2/0.
[Sysname] interface wlan-radio 2/0
[Sysname-WLAN-Radio2/0] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
[Sysname-WLAN-Radio2/0] wmm enable
[Sysname-WLAN-Radio2/0] wmm svp map-ac ac-vo
[Sysname-WLAN-Radio2/0] wmm edca radio ac-vo ecw ecwmin 0 ecwmax 0
[Sysname-WLAN-Radio2/0] quit
IP network
L2 Switch
FAT AP
Client