H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 154)

143
GigabitEthernet1/0/1 GigabitEthernet1/0/2 GigabitEthernet1/0/5
VLAN ID: 2
VLAN Type: static
Isolate-user-VLAN type : secondary
Route Interface: not configured
Description: VLAN 0002
Name: VLAN 0002
Tagged Ports: none
Untagged Ports:
GigabitEthernet1/0/2 GigabitEthernet1/0/5
VLAN ID: 3
VLAN Type: static
Isolate-user-VLAN type : secondary
Route Interface: not configured
Description: VLAN 0003
Name: VLAN 0003
Tagged Ports: none
Untagged Ports:
GigabitEthernet1/0/1 GigabitEthernet1/0/5
Configuration example for configuring the uplink
port to permit multiple isolate-user-VLANs
Network requirements
As shown in Figure 43 , Device B is attached to Device A.
Configure the isolate-user-VLAN feature, so that:
• VLAN 5 and VLAN 10 are isolate-user-VLANs on Device B. The uplink port GigabitEthernet 1/0/1
permits packets from VLANs 5 and 10 to pass through tagged.
• On Device B, the downlink port GigabitEthernet 1/0/2 permits secondary VLAN 2 and the
downlink port GigabitEthernet 1/0/3 permits VLAN 3. Secondary VLANs 2 and 3 are associated
with isolate-user-VLAN 5.
• On Device B, the downlink port GigabitEthernet 1/0/6 permits secondary VLAN 6 and the
downlink port GigabitEthernet 1/0/8 permits VLAN 8. Secondary VLANs 6 and 8 are associated
with isolate-user-VLAN 10.
• Device A identifies only VLANs 5 and 10 on Device B.