Setting the lldp operating mode, Setting the lldp re-initialization delay – H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 187
176
To enable LLDP:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable LLDP globally.
lldp enable
By default, LLDP is globally
enabled.
3.
Enter Ethernet interface
view or port group view.
•
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
Use either command.
4.
Enable LLDP.
lldp enable
Optional.
By default, LLDP is enabled
on a port.
Setting the LLDP operating mode
LLDP can operate in one of the following modes:
•
TxRx mode—A port in this mode sends and receives LLDPDUs.
•
Tx mode—A port in this mode only sends LLDPDUs.
•
Rx mode—A port in this mode only receives LLDPDUs.
•
Disable mode—A port in this mode does not send or receive LLDPDUs.
To set the LLDP operating mode:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Ethernet interface
view or port group view.
•
Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
Use either command.
3.
Set the LLDP operating
mode.
lldp admin-status { disable | rx | tx | txrx }
Optional.
The default LLDP operating
mode is TxRx.
Setting the LLDP re-initialization delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after a
certain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations caused
by frequent changes to the LLDP operating mode on a port.
To set the LLDP re-initialization delay for ports:
Step Command
Remarks
1.
Enter system view.
system-view
N/A