H3C Technologies H3C SecPath F1000-E User Manual
Page 208
Advertising
196
Figure 125 Configure an IPsec policy
•
Enter map1 as the policy name.
•
Enter 10 as the sequence number.
•
Select the IKE peer of peer.
•
Select the IPsec proposal of tran1 and click <<.
•
Enter 3101 as the ACL.
•
Select Enable for RRI.
•
Enter 2.2.2.2 as the next hop.
•
Click Apply.
# Apply the IPsec policy to interface GigabitEthernet 0/1.
Select VPN > IPSec > IPSec Application from the navigation tree, and then click the
icon of interface
Serial 2/1 to enter the IPsec application page. Perform the configurations shown in
.
Advertising
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS