H3C Technologies H3C SecPath F1000-E User Manual
Page 262
Advertising
250
•
Enter password Hello.
•
Enter Hello to confirm the password.
•
Click Apply.
# Enable L2TP.
•
Select VPN > L2TP > L2TP Config from the navigation tree. Then, perform the configurations shown
in
Figure 161 Enabling L2TP
•
Select the Enable L2TP box.
•
Click Apply.
# Add an L2TP group
•
On the L2TP configuration page, click Add and then perform the following configurations.
•
Enter the L2TP group name test.
•
Enter the peer tunnel name vpdnuser.
•
Enter the local tunnel name LNS.
•
Select Disable for Tunnel Authentication.
•
Select CHAP as the PPP authentication method.
•
Select ISP domain system (the default ISP domain).
•
Click the Modify button of the ISP domain to perform the configurations shown in
Advertising
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS