H3C Technologies H3C SecBlade LB Cards - Manual (Page 71)

63
1::10
Virtual MAC : 0000-5e00-0201
Master IP : FE80::1
Interface GigabitEthernet0/1
VRID : 2 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Become Master : 2200ms left
Auth Type : None
Virtual IP : FE80::20
1::20
Master IP : FE80::2
# Display the detailed information about the VRRP group on LB B.
[LBB-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 2
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Become Master : 2200ms left
Auth Type : None
Virtual IP : FE80::10
1::10
Master IP : FE80::1
Interface GigabitEthernet0/1
VRID : 2 Adver Timer : 100
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : FE80::20
1::20
Virtual MAC : 0000-5e00-0202
Master IP : FE80::2
The output shows that in VRRP group 1, LB A is the master, LB B is the backup, and the host with the
default gateway of 1::10/64 access the Internet through LB A. In VRRP group 2, LB A is the backup,
LB B is the master, and the host with the default gateway of 1::20/64 access the Internet through
LB B.
NOTE:
To implement load balancing between the VRRP groups, be sure to configure the default gateway as 1::10
or 1::20 on the hosts on network segment 1::/64.